ATMEL USB JUNGO DRIVER

I have the same question Note Firmware version 3 and later uses a HID interface for communication. Thank you for your quick response. In reply to DeanP’s post on February 25, You can follow the question or vote as helpful, but you cannot reply to this thread. My STK was not detected either by Studio 5.

Uploader: Kagakinos
Date Added: 17 December 2018
File Size: 31.74 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 7044
Price: Free* [*Free Regsitration Required]

Sorry, your blog cannot share posts by email.

I’m new junbo this forum and I tried unsuccessfully to locate a similar question. In reply to DeanP’s post on February 22, Now launch a command prompt with elevated privileges Right click cmd. As for your questions, this is only an issue with this particular device.

Then after completion go to the install location of Jungo.

AVR Jungo USB by Atmel – Should I Remove It?

In reply to DeanP’s post on February 25, Then goto the usb64 folder from command prompt as administrator. Ian Bakshan Replied on February 24, Now check if things work, in some case you might be lucky Now inside that folder there will be two folders usb32 and usb64, since we are here for a Win 7 hungo cause we should use the usb64 folder.

  AMD/ATI IXP SB4X0 SMBUS CONTROLLER DRIVER

This thread is locked. Some symptoms are as follows.

Thank you for your quick response. Hello, I’m new to this forum and I tried unsuccessfully to locate a similar question. Thanks for taking the time to read through my question. Yes it does, I am able to see it in the programming dialog of studio 5. In reply to Ratandeep’s post on February 22, DeanP Replied on February 25, Note Firmware version 3 and later uses a HID interface for communication.

Shows up in Device Manager: Post was not sent – check your email addresses! This is new territory for me. Thanks for marking this as the answer. So to make it work I followed these steps.

Update a driver for hardware that isn’t working properly http: I would like to know some information about the issue so that we could help you better. Both drivers will be under “Jungo Connectivity”.

Jungo Connectivity Driver

You can alternatively use your own path rather than c: Extract the Jungo Installer from Studio. This site in other languages x. By continuing to use this website, you agree to their use.

  DR-4010C CANON DRIVER

But am pretty sure that the Jungo USB driver just launches the wdreg. Jungk feel free to reply, in case you face any other issues with Windows in future.

Can anyone tell me how I can purge all the remnants of these drivers so that I can attempt a successful re-install? Hello Dean, Thank you for keeping us updated on the status of the issue.

I assumed this might be enough to allow the driver to automatically install when I restart my PC and plug in the programmer but this is unfortunately not the case. Hello Dean, Thank you for posting your question on Microsoft Uab.